Bmw 520 motronik cramshaft схема

bmw 520 motronik cramshaft схема
This tech article will help you determine your year, model and what equipment was available for your vehicle. Take the unit apart and expose the two circuit boards (Figure 3). Although I have not used it myself, I have had several Pelican Parts customers tell me that spraying the board with WD-40 helps to dispel any water, dries the board, and sometimes works. The rear axle is mounted on a delta beam that is connected to the body with three screws in rubber bearings, that have longitudinal play. Applies to: 525i (2006-10), 528i (2006-10), 530i (2006-10), 525ix (2006-10), 528xi (2006-10), 530xi (2006-10) NG6 Engine Fuel Injectors Replacement This tech article shows you how to replace the fuel injectors on the BMW E60 models with NG6 engines. Tech Forums Extras Basics & Essentials Changing the Oil and Filter in Your E60 BMW 5-Series New to working on your car?


These valve can fail causing noise, drivability and sometimes enter the engine in pieces. Now we will start to go deeper into the Motronic system. *Problems with the system’s power supply and or grounds will often cause the engine to quit running and or prevent the car from starting. If your car cranks over but won’t start, this is probably the section for you. Those are the terminals we will be checking. There are a lot of vacuum hoses on these cars, many of which are not visible in this photo. These transmissions were only installed in the 1986-1988 model years. If you have this transmission, you have the other throttle position switch.

Check your fault codes first using a BMW scan tool. If you have a fault for a wheel speed sensor, use this tech article to learn how to replace quickly and easily. While the M30 camshaft is chain driven, the M20 camshaft and auxiliary shaft are driven by a timing belt. Applies to: 525i (2004-05), 530i (2004-05), 528i ( -), 525ix ( -), 528xi ( -), 530xi ( -), 535i ( -), 535xi ( -), 545i ( -), 550i ( -) M54 Engine Camshaft Sensor Replacement Camshaft sensor fault codes, stalling engine or rough idle?

Похожие записи: